Rheinzink offer complete rainwater system to match their Bright Rolled, Pre Patina Blue Grey and Pre Patina Graphite Grey finishes. The systems they produce are aimed at different building types and sizes and are available in half round and box section.

Rheinzink offer a 250 half round gutter specifically designed for the Domestic Market. This covers anything from a small extension to a medium / large sized house. The gutter joints, corners and running outlets need to be soldered.  Gutter size 105mm with downpipes at 80mm. Gutter bracket spacing 400mm to ensure the system copes with potential snow loading / Downpipe brackets 1 per metre.

Rheinzink 333 is aimed at large housing with large high pitched roofing and also small commercial buildings. Being a large gutter and downpipe combination the system is better equipped to handle high quantities of rainwater run off at a much higher speed than their 250 gutter ensuring effective clearance of the roof. Rheinzink 333, also known as 333 Half Round or 333 Box Gutter are 153mm diameter and  120mm wide respectively in section with downpipes at 100mm. All brackets and clips are far stronger to cope with the weight and snow loads. Gutter bracket spacing 400mm / Downpipe brackets 1 per metre. The system requires all gutter joints, corners and running outlets need to be soldered.

Further to the 250 and 333, Rheinzink also offer the 400 gutter for large commercial buildings. Downpipes are also possible in 120mm for this system.

When selecting any gutter system, the height and pitch of a roof affects the total area and speed and quantity of rainwater run off. Rainwater calculations can be carried out to ensure that the gutter specified will cope with run off in the worst possible conditions. If you are unsure which size gutter best suits your building requirements, please contact us with full dimensions of the roof area along with roof pitch/slope and project location.

Downpipes and bends for all systems have male and female sockets allowing quick install without the requirement for glue or solder.

JMR hold extensive stocks of each system to ensure project deadlines are met. For items not in stock a 2/3 week lead time should be expected.